Svs 7HSE 110V Manual do Utilizador

SVS 7HSE LIFTINSTALLATION INSTRUCTIONS(110V)SVS, INC. Lifting Your Image2513 Jenks AvePanama City, FL 32405www.svslifts.comTel: 850-522-4747Fax:

1. Make sure that the area below the Lift is clear and that all cable are clear of the Lift.2. Apply power to the Lift by plugging it into an AC Outle

4. Hold relays on to raise/lower the Lift.5. Never leave voltage on the up and down. Always program a release after the travel time has been achiev

Figure 10 5 ¼ complete turns for the SVS 7HSE-18 6 complete turns for the SVS 7HSE-20  6 ½ complete turns for the SVS 7HSE-22Warning: Over-winding

2. Loosen the thumb screw holding the Show microswitch (bracket) in place and slide the Show microswitch (bracket) along the Lift fra

WARNINGTo prevent personal injury and property damage when servicing any part of the lift drive system (electric motor/brake, drive chain/sprockets, s

14. TROUBLESHOOTINGAll SVS Lifts are quality checked before they leave the SVS Factory and are fully operational. Shipping damage and inst

Lift works with the key switch in the Service position but will not lower in the Show positionThe Show position microswitch may be set too near the re

SVS 7HSE LIFTINSTALLATION INSTRUCTIONSSECTIONS: Page 1. General Description...

SVS 7HSE LIFT1. General Description:The SVS 7HSE Lift supports large projectors requiring additional weight and size accommodations. This model is s

3. SVS 7HSE LIFT WARRANTYSVS, Inc. 's limited warranty only covers failures due to defects in materials or workmanship that occur during normal u

IMPORTANT: PLEASE READ THROUGH ALL INSTRUCTIONSBEFORE BEGINNING YOUR INSTALLATION.This Lift is designed to be used with a Wall Plate Controller, eithe

• As a reminder, clear all persons and obstructions from the Lift's path during its operation. Keep fingers and other objects away from the sciss

6. LIFT SUPPORTING STRUCTUREThe SVS 7HSE Lift should be mounted from six 1/2” rods. The mounting hole locations are marked with a <M> in Figure

If the ceiling clearance allows, an “X-Y” or a cross-supporting structure is strongly suggested as shown in Figure 6 Recommended Lift Support Structur

b. Installing the Lift in the Ceiling1. Raise the Lift into the ceiling and line up the six (6) mounting holes in the Lift's top frame